Align Trex 450 RC Helicopter Crash - Servant abortion in flight (the BEASTX) On YouTube.
My tragedy today. One of the good times Servo (9g Towerpro) failed in flight and caused the crash. It happens when I punch the gas light to give a certain amount of Heli Coming Down Hard is back, and when I noticed that something was not strange that it's too late - with the exception of only a general rule .. Autorotation beat! Post-morterm investigation I discovered the servant on the right side stopped working, while the highest position, the plug has caused high positive slope Helicopterand roll at the end. I know I'm stupid choice, but I would not recommend to my mates and cheap analog servo from my personal experience with clear, particularly with the system flybarless. It is fortunate that nobody was injured by the accident. In fact, I'm lucky twice today - a little of this incident by a 'Dremel (end broke something during the full rotation rpm and hit right between the eyes .. even if I went to A & E to ensure the everything is ok)
Tags: TREX, Align, T-rex, 450, rc, helicopter, crash, servo, failure, flying, remote, control, beastx
No comments:
Post a Comment